Warning & Hazard
- Light Bars keyboard_arrow_right
- Strobe Lights keyboard_arrow_right
- Directional Warning Lights keyboard_arrow_right
- Beacons keyboard_arrow_right
- Warning & Hazard Lights Accessories keyboard_arrow_right
- Flashers keyboard_arrow_right
- Audible Devices keyboard_arrow_right
- Traffic Safety keyboard_arrow_right
Electrical Connections
- Trailer Connectors keyboard_arrow_right
- Air Products keyboard_arrow_right
- Terminals & Connectors keyboard_arrow_right
- Wire & Cable keyboard_arrow_right
- Support & Protective keyboard_arrow_right
- Switches & Electrical Assemblies keyboard_arrow_right
- Battery Connectors & Cables keyboard_arrow_right
- Kits & Tools keyboard_arrow_right
Company
- Company Profile keyboard_arrow_right
- Careers keyboard_arrow_right
- Case Studies keyboard_arrow_right
- Contact Us keyboard_arrow_right
- Media Center keyboard_arrow_right
- Grote News keyboard_arrow_right
- Trade Shows & Events keyboard_arrow_right
- Quality keyboard_arrow_right
- Star Safety Technologies by Grote keyboard_arrow_right
Tech Support & Information
Customer Information
Knowledge Base
- What is S-LINK TECHNOLOGY?
- I am looking for installation wiring diagram for 77931
- Were to find a install instruction for 78473 light bar? Or trouble shooting. Unit just blinks on the pad does not light up lights on bar.
- What is S-LINK TECHNOLOGY?
- I am looking for installation wiring diagram for 77931
- Were to find a install instruction for 78473 light bar? Or trouble shooting. Unit just blinks on the pad does not light up lights on bar.
- What is S-LINK TECHNOLOGY?
General
- How long does the BZ501-5 take to charge?
- Pigtail male end to go into your 53782 light assembly.
- Do LED headlights produce enough heat to melt snow off of them for safe winter driving?
- Can I replace my incandescent 6493 lights with the 77193 LED lights? If yes, are there other changes I would need to make to my current system?
- I have a customer that uses the 48282 turn signal switch(and 69690 harness). What’s the pin-out for this switch?
- Do plate lights # 60251 and # 60151 meet the SAE standard?
- I would like more info on becoming a Grote dealer.
- Where do I go to cross reference part numbers?
Lighting
- I would like installation instructions on the 53962 light only, grommet seems fine. This looks like a snap-in light, I just need to know how to go about doing it.
- How do I separate the red lens from the white housing in a Grote 5218 trailer light in order to change a burnt out bulb?
- I always seem to struggle when installing a 6 ½ inch oval lamp. Should you install the gasket to the vehicle first then the lamp? Is there some kind of trick to ease installation?
- I am looking for installation wiring diagram for 77931
- How do I install the Grote 64930 Par 36 Utility Lamp with only one wire coming out of the light?
- Were to find a install instruction for 78473 light bar? Or trouble shooting. Unit just blinks on the pad does not light up lights on bar.
- How do I install Grote’s 4×6 high / low beam led headlight 94401-5?
Installation
- Wiring Diagram for 77365. Can I make this act as a non strobe so that I can include it onto a 99630 module?
- Are 63F31 dimmabled? What happen if I lower the supply current below 1.5A?
- I’ve installed a pair of your LED 5×7 headlights in a 2005 IH 9900i. Hi and Lo beams work, but with just the day time running lights on they flicker and strobe. turn on the headlights and they work fine. What’s up with this?
- What is the amp draw or watts of the 12V 64931 tractor lamp?
- Can I add extra lights on my Truck, Tractor, Trailer or Body, over and beyond the legal requirements in FMVSS108?
- Is it required for the driver to see the bottom rear side marker lamp or commonly called the tracking lamp?
- Are clear lenses on rear stop, turn, and tail signal lamps legal?
Wiring
- What circuit is White and Amber with 94820-5?
- Which wire is for brake, red or black? Part #53052
- What are the wire color descriptions for Grote 61121 Clear LED WhiteLight X-100 Dome Light?
- I am wiring a pair of 52572 taillights. There are only 3 terminals, one is ground, so I connected both turn and stop to one terminal. But when I turn on my turn signal, all four turn signals(both sides) are energized. Will this light perform all 3 functions (tail, stop, and turn) ?
Are you unable to find an answer to a question? Submit your question and we will get back to you.
Ask us a Question!
Can't find the answer that you we're looking for? Please fill out the following form and once answered, we will add it to our FAQ.
We will not publish your name or email address. Thank you!